Loading...
HomeMy WebLinkAboutA14-0011 SD500MIM.pdfP/N 151071 SD500-AIM Input Module and SD500-MIM Mini Input Module Installation Instructions The following instructions are a quick reference guide, refer to the control panel installation manual P/N 151139, 151274, 151280, 151295, 151209, or 151302 for detailed system information. Wiring the SD500-AIM / MIM Note:Installation and wiring of these devices must be done in accordance with NFPA 72 and local ordinances. Terminate the wiring as shown in Table 1. See also Figure 1 or Figure 2 Specifications Table 2 lists the operating specifications for the SD500-AIM and the SD500-MIM. Impedance for Earth Ground Fault is 0 Ω for all terminals. Figure 1: Class B Wiring the SD500-AIM & SD500-MIM Table 1: Wire Connections SD500-AIM SD500-MIM Terminals To: FACP or SLC Loop Terminals Contact SLC –SLC OUT SC– +S+ Contact A out CLASS A OR B To N.O. Contact B out To N.O. Contact A IN CLASS A ONLY (SD500-AIM Only) End of Loop A End of Loop BB IN Table 2: SD500-AIM and SD500-MIM Specifications Specifications Max. Line resistance 50Ω Max. Alarm Current One device in alarm 23mA. 46 mA for two devices in alarm. .5 mA for each addi- tional device in alarm. Max. Voltage 33 V Operating Temperature 0° to 49° C (32° to 120° F) Indoor use only Table 2: SD500-AIM and SD500-MIM Specifications Specifications Alternate Construction SD500-AIM Input Module and SD500-MIM Mini Input Module Installation Instructions 2 7550 Meridian Circe, Suite 100Maple Grove, MN 55369-4927763-493-6455 or 800-328-0103Fax: 763-493-6475www.silentknight.com © 2008 Honeywell International Inc. PN 151071 Rev G Figure 2: Class A Wiring the SD500-AIM Mounting the SD500-AIM Mount the SD500-AIM into a double gang box as shown in Figure 3. Mounting the SD500-MIM Install the SD500-MIM into a single gang box see Figure 1 and Figure 3. Figure 3: Mounting the SD500-AIM and SD500-MIM Setting the Devices Address The range of valid addresses is 1 - 127 (0 is an invalid address). Refer to Figure 4 to set the dip switches to the desired address. Figure 4: Setting the Device Address: Note:The dip switch settings shown in Figure 4 apply to the SD500-MIM also. Status LED