HomeMy WebLinkAboutFP1.pdfTHIS SET OF FIRE SPRINKLER SHOP
DRAWINGS HAVE BEEN REVIEWED
AND FOUND TO BE ACCEPTABLE BY
TIMOTHY N. TROSTEL, JR - N.I.C.E.T.
IV # 102055. SR. ENGINEERING
TECHNICIAN - FIRE PROTECTION
NATIONAL INSTITUTE FOR CERTIFICATION IN
ENGINNERING TECHNOLOGIES
____________________________________/____/____
ACCEPTING THIS COPY IS DEEMED AS AGREEING TO THE FOLLOWING: THIS DRAWING COPY, ITS CONTENTS,
INFORMATION AND PRINCIPALS OF DESIGN ARE THE EXCLUSIVE PROPERTY OF THE FIRE PROTECTION
CONTRACTOR LISTED AND MILE HIGH DESIGN GROUP, LLC AND IS BEING SUBMITTED TO YOU WITH THE
UNDERSTANDING THAT IT IS NOT TO BE REPRODUCED, COPIED OR MODIFIED IN ANY MANNER; NEITHER SHALL
IT BE RELAYED IN WHOLE OR IN PART TO ANY OTHER INDIVIDUAL OR FIRM FOR ANY OTHER PROJECT OR
EXTENSION OF THIS PROJECT EXCEPT THRU WRITTEN AGREEMENT WITH THE FIRE PROTECTION CONTRACTOR
AND MILE HIGH DESIGN GROUP, LLC. ERRORS AS A RESULT OF THIS FILE BEING ELECTRONICALLY
TRANSMITTED ARE BEYOND THE CONTROL OF AND ARE NOT THE RESPONSIBILITY OF THE FIRE PROTECTION
CONTRACTOR OR MILE HIGH DESIGN GROUP. MILE HIGH DESIGN GROUP IS NOT RESPONSIBLE FOR
INSTALLATION OR INSPECTION OF WORK INSTALLED. THESE PLANS ARE DIAGRAMMATICAL ONLY. ON SITE
COORDINATION MUST BE ARRANGED WITH ALL OBSTRUCTIONS, i.e.: MECHANICAL, ELECTRICAL, AND
STRUCTURAL. ANY ALTERATIONS FROM ENGINEERED DRAWINGS MUST BE APPROVED BY MILE HIGH DESIGN
GROUP. MILE HIGH DESIGN GROUP IS NOT RESPONSIBLE FOR LAYOUT DESIGN ISSUES OR CONFLICTS WITH
ANY OBSTRUCTIONS. IF ADDITIONAL FIRE SPRINKLER PIPING AND/OR FIRE SPRINKLER HEADS ARE REQUIRED
THIS WILL BE THE RESPONSIBILITY OF THE FIRE SPRINKLER CONTRACTOR. ALL CHANGES MUST ME APPROVED
BY MILE HIGH DESIGN GROUP, LLC
THE OWNER IS RESPONSIBLE TO PROVIDE SUFFICIENT HEAT THROUGHOUT THIS BUILDING TO PREVENT
FREEZING OF WATER IN THE FIRE SPRINKLER SYSTEM -
GENERAL NOTES PER NFPA 13, 2010 EDITION
ALL FIRE SPRINKLER MAIN PIPING ARE TO BE SCH 10 OR
EQUIVALENT. BRANCH LINES ARE TO BE SCH 10 AND SCH 40
OR EQUIVALENT. ARMOVERS AND DROPS/SPRIGS ARE TO
BE SCH 40 OR EQUIVALENT. OUTLETS TO BE WELD-O-LETS
FOR THE FIRE SPRINKLER HEADS AND PIPE OUTLETS
HANGERS TO CONFORM TO NFPA 13 FOR SPACING AND
PIPE TO BE SUPPORTED BY RING HANGER AND (3/8" FOR 1 ~
4 INCH) AND (1/2" FOR 6 ~8 INCH) ALL THREAD ROD WITH
ATTACHING DEVICE (BEAM CLAMP, SAMMY SCREW OR HILTI
DROP-IN)
START POINT OF WORK TO BE FROM THE EXISTING FIRE
SPRINKLER SYSTEM
ALL FIRE SPRINKLER HEAD RELOCATED WILL BE REPLACED
WITH NEW HEADS TO MATCH THE EXISTING HEADS IN THE
AREA OF WORK
THIS RESTROOM AREA IS ALL LIGHT HAZARD AREA
Received
By Carolyn Godfrey at 3:36 pm, Oct 02, 2014
F14-0060
Vail Fire & Emergency Services
10/07/14